Landoll 7431 VT Plus User Manual download pdf (Page 90)

4-22 F-561-0113 Edition

OPERATION AND MAINTENANCE

Storage

1. The service life of the VT Plus will be extended by

proper off-season storage practices. Prior to storing

the unit, complete the following procedures:

a. Completely clean the unit.

b. Inspect the machine for worn or defective parts.

Replace as needed.

c. Repaint all areas where the original paint is worn

off.

d. Grease all exposed metal surfaces of shanks,

points and discs.

e. Apply a light coating of oil or grease to exposed

cylinder rods to prevent them from rusting.

f. Lubricate each point of the machine as stated in

“Lubrication Maintenance” on page 4-21.

2. Store the unit in a shed or under a tarpaulin to protect

it from the weather. The ground tools and tires should

rest on boards, or some other object, to keep them

out of the soil.

3. If the unit must be stored outside, unfold the VT Plus

to prevent moisture buildup in the disc gang and

wheel bearings.

4. If the unit is stored in the folded position, make sure

the transport lock pins are installed to prevent wing

frames settling.

5. Slide the rear jack tube from transport position and

into slot from bottom of rear jack mount. Pin jack tube

in position. Attach jack to rear jack tube and pin in

position. Crank jack until the rear of the machine is

supported (See Figure 4-23.)

Figure 4-23: Rear Jack Transport Position

REAR JACK

MOUNT

LOCK PIN

AND 1/4 X 3

ROLL PIN

REAR JACK

SQUARE TUBE

JACK

REAR FRAME

rear jack storage position

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 96 97 98

Comments to this Manuals

No comments

Landoll 7431 VT Plus User Manual Page 90

Comments to this Manuals

Related products and manuals for Special machinery Landoll 7431 VT Plus