Landoll 7431 VT Plus User Manual download pdf (Page 66)

3-42 F-561-0113 Edition

ASSEMBLY INSTRUCTIONS

Rear Jack Installation

A rear jack assembly is available for use on the rear of

the VT Plus.

IMPORTANT

The rear jack tube should be located to the rear of the

VT Plus near the center of the frame, but not

interfering with the visibility of the SMV sign.

1. Slide rear jack assembly over rear frame of the VT

Plus near the center of the frame (See Figure 3-34.)

2. Slide rear plate onto 3/4-10 x 4 hex head cap screws

beneath rear frame tube and hold in place with

3/4-10 hex lock nuts.

Figure 3-34: Rear Jack Installation

Final Assembly

1. Attach a tractor to the implement and charge the lift

system hydraulics as described is “Hydraulic Lift

System” on page 4-3.

2. Install the transport locks on both 4 x 10 master

cylinders on the center frame.

3. Connect the hydraulic hoses on the optional

hydraulic leveler to the tractor (if equipped). Fully

extend and retract the hydraulic leveler several times

to remove any air. See “Hydraulic Leveler

Adjustment” on page 4-11 for any further

adjustments

4. The fold system must be purged of air and filled with

oil BEFORE attempting to fold the implement. Air in

the system will allow the wings to fall uncontrollably

and may result in implement damage. Follow

instructions for charging the hydraulic fold system as

described in “Hydraulic Fold System” on page 4-5.

5. Connect lights to the tractor and verify operation.

6. Check tires for proper inflation

7. Level the disc from side to side as described in

“Leveling (Side to Side)” on page 4-8.

8. Inspect the final implement assembly, and verify that

all bolts have been tightened, cotter pins spread, and

that there are no leaking hydraulic connections.

9. Rotate each disc gang to verify that each gang

rotates freely. Adjust any scrapers that may have

shifted during shipment or assembly.

10. Lubricate the disc at all locations (See “Lubrication

Maintenance” on page 4-21.)

11. Touch up with paint any areas that may have been

scratched during moving, handling, or assembly.

12. Thoroughly read and understand the operating

section before using the disc.

REAR JACK ASSEMBLY

REAR FRAME

3/4W FLAT

WASHER

3/4-10 X 4 HEX HEAD

CAP SCREW GR5

REAR JACK PLATE

3/4-10 HEX LOCK

NUT GRB

m156953 installation

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 97 98

Comments to this Manuals

No comments

Landoll 7431 VT Plus User Manual Page 66

Comments to this Manuals

Related products and manuals for Special machinery Landoll 7431 VT Plus