Landoll 9650 Field Cultivator User Manual download pdf (Page 45)

ASSEMBLY INSTRUCTIONS

3-5

Leveling Linkage Assembly

IMPORTANT

Read all safety precautions at the front of the section

before attempting any of the following procedures.



WARNING

NOTE

If installing optional rear tow hitch, see “Rear Tow Hitch

(Option)” on page 3-25. Install rear tow hitch before

connecting leveler tube.

1. Slide leveler tube under the wing stabilizer.

2. Attach rear of leveler tube to the center lift using hitch

pin, 1-1/2 flange bearings, 1/2 x 2-1/4 grooved alloy

pin, and 1-8 hex lock nut (See Figure 3-2.)

3. Attach leveler tower to the rear of hitch using 1-1/4-7

x 9-1/2 hex head cap screw, 1-1/4-7 split lock

washer, and hex nut.

4. Attach the top of the leveler tower to the leveler tube

with hitch pin, 1-1/2 flange bearings, 1/2 x 2-1/4

grooved alloy pin, and 1-8 hex lock nut.

5. Assemble radius rod assembly to top front hole in the

leveler tower using 1-1/4-7 x 8 special hex head cap

screw, flat washers, split lock washer, and hex nut.

6. Attach front of radius rod assembly to hitch using

1-1/4-7 x 8 special hex head cap screw, flat washer,

split lock washer, and hex nut.

Do not attempt to lift heavy parts (such as the

frame, rock shaft, and pull hitch) manually. Use a

hoist or a fork lift to move these parts into

position.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

No comments

Landoll 9650 Field Cultivator User Manual Page 45