Landoll XXLO184 X-Fold Pulverizer User Manual download pdf (Page 15)

190rev501 9J698

Page 10A

OPTIMIZER WHEEL PLACEMENT

38’ - 46’ Wide Models with

20” Optimizer Wheels - 4 ” bore

(6K351 Wheel & 6K352 End Wheel)

CENTER SECTION

(2x)13 Wheels, (2x)2 End Wheels)

NOTE: Wheel Gangs on the XXL model Optimizer wings are not identical -

on some the pipe shaft extends farther out beyond the wheels. Place these

on the outside end of the machine.

The above diagram shows wheel gang positioning and assembly for the

center and wings of optimizer model pulverizers using

optimizer wheels.

When assembling, position the axle clamps toward the outside end of the

wing and the machine. Also, it is especially important that fit of wheels

on the shaft remains tight. Wear and damage can result from wheels

that do not fit tightly against one another. Make frequent checks to insure

that close fit remains intact. If wheels have jostled apart, adjustment is

made by loosening and moving the clamp until the wheels are tightly in

place. Then retighten clamp.

Position All Axle Clamps to ends

opposite Center Bearing

Center Brkt & Brng

6K351

Optimizer

Wheel

“XXLO” Models

Male &

female hub ends must

mate and remain in

close contact.

11’ Wing - 140 1/2

12’ Wing - 152 1/2”

13’ Wing - 164 1/2”

14’ Wing - 176 1/2”

15’ Wing - 188 1/2”

183 13/16”

90 3/4”

Center Brkt & Brng

6K506=10 Wheels + 6K505=12 Wheels

6K509=12 Wheels + 6K505=12 Wheels

w/ Longer Pipe

6K510=14 Wheels + 6K505=12 Wheels

6K510=14 Wheels + 6K505=14 Wheels

6K504=15 Wheels + 6K504=15 Wheels

w/ Longer Pipe

6K505=12 Wheels + 6K506=10 Wheels

Place wheel gang that has pipe

which extends beyond wheels to

the outside end of the machine.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Comments to this Manuals

No comments

Landoll XXLO184 X-Fold Pulverizer User Manual Page 15

Comments to this Manuals

Related products and manuals for Special machinery Landoll XXLO184 X-Fold Pulverizer